![]() Who do you want to allow to change dimensions? To allow people to make changes, assign the D365 DIM CORRECTION permission to the users.Are there dimensions that you do not want to allow people to change? On the Dimension Correction Settings page, specify the dimensions that you want to block for changes.There are two things to consider when setting up dimension corrections: There will be a mismatch between the dimensions assigned in the general ledger and the sub-ledgers. They do not change the dimensions assigned to the entries in other ledgers for the same transaction. Dimension corrections apply only to the G/L entries. The features for correcting dimensions are intended only to help make financial reporting accurate. That will help keep your financial reports and analyses accurate. If you discover that an incorrect dimension has been used on posted general ledger entries, you can correct the dimension values and update your analysis views. This resets the changes, and you can run the correction again.Ĭhanging Dimension Assignments After Posting Choose Reset to revert the correction to a draft state. Remove the conflicting line from the dimension set.Ī dimension correction does not complete correctly. Change the Value Posting field on the Default Dimension page. Unexpected dimension value for default dimension where the Value Posting field contains No Code Enter a blank dimension value code for the conflicting dimension in the dimension set. Non-blank dimension value code for blank default dimension where the Value Posting field contains Same Code Enter the required dimension value for the conflicting dimension in the dimension set. Wrong dimension value code for default dimension where the Value Posting field contains Same Code Enter a non-blank dimension value for the conflicting dimension in the dimension set. ![]() Modify one of the conflicting permission set line for the dimension value combination.īlank dimension value code for default dimension where the Value Posting field contains Code Mandatory Find non-posted documents containing the dimension set with the blocked dimension value combination and unblock it. Modify one of the conflicting permission set line for the dimension combination.ĭimension combinations %1 - %2 and %3 - %4 can't be used concurrently. Find non-posted documents containing the dimension set with the blocked dimension combination and unblock it. Remove the dimension set line for the blocked dimension value.ĭimensions %1 and %2 can't be used concurrently. Change the Dimension Value Type field on the Dimension Values page to Standard or Begin-Total. Remove the dimension set line for the missing dimension value.ĭimension Value Type for %1 %2 - %3 must not be %4. Find non-posted documents containing the dimension set with the missing dimension value and add it. Remove the dimension set line for the blocked dimension value. Find non-posted documents containing the dimension set with the blocked dimension value and unblock it. Remove the dimension set line for the missing dimension. Find non-posted documents containing the dimension set with the missing dimension and add it. Remove the dimension set line for the blocked dimension. ![]() Find non-posted documents containing the dimension set with the blocked dimension and unblock it. could appear in the UI as "Dimension Code AREA is blocked.". In the following list of potential error messages, the %X codes are placeholders for the data variables that the actual message will contain in the UI depending on the context.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |